Icecast Streaming Media Server

[mmarulanda]

Hi,

With limit-rate i can limit that, but in 2.3.2 this don't work.

How do I limit the rate in icecast 2.3.2?

[karlH]

That option is only in the kh tree on my website.

karl.

[mmarulanda]

Thank you...

But how works that and how install the kh in linux?

if that kh a icecast complement or a icecast recoded?

[karlH]

You build the kh codebase like you would 2.3.2 using the same configure, make and make install approach. You then start that icecast with the xml you want.

karl.

[mmarulanda]

Ok, thanks

where i put <limit-rate>64k</limit-rate>?

I can limit the mount banwidth with kh?

with that i can view the current bandwidth?

[karlH]

Yes, by placing that setting into the appropriate mount section then that setting will apply to that stream. The current incoming bitrate is reported via the stats, it is already viewable via /admin/stats but you can add it to the webroot xsl pages if you really want it on there as well.

karl.

[mmarulanda]

Hi karl

Now after install the kh (icecast 2.3.2kh), i can't stop the icecast with the usually command line

kill -s INT {PID}

that command line not kill the process, but if i have installed only icecast (icecast 2.3.2) that line working.

How i do to kill the proccess or stop icecast?
my OS is CentOS 5.5

[karlH]

strange, the signal handler is no different, and the exact command works here. I'm assuming TERM does the same thing as INT, if so lets see the error log to see what is happening after the signal is detected.

karl.